Tazer JL/JT MINI Programmer

Perf Menu:

Adjust for alternate tire sizes up to 42''
Adjust for alternate axle gear ratios
Adjust for an alternate transfer case LO range ratio

TPMS Menu:

Disable TPMS system if desired
Change front/rear TPMS warning PSI limit

Radio Menu:

Disable Backup camera
Enable Cargo Camera input
Enable CD audio input
Disable TravelLink (weather warnings included)

Lighting Menu

Change DRL region (type)
Change DRL location
Disable DRL Dropout
Enable Fog lamp output
Disable Fog lamp dropout
Disable Halo’s
Set LED 3rd brake light type
Set LED tail lamp type
Set LED front turn signal type
Set Trailer Tow output for use with Mopar kit

Other Menu:

Disable/Enable Electronic sway bar – for axle swaps or to run disconnected at any speed or drive mode
Disable/Enable Front Axle Disconnect
Disable/Enable Front and Rear Lockers
Enable Aux switch settings on the radio
Enable Blind spot detection (sensors required)
Change cluster splash screen to Wrangler/Sahara/Rubicon
Enable/Disable PANIC button on remote

Live features - these run only while the tazer is plugged in:

Light shows: Can be accessed from the key fob or from the on-screen menu. 6 pre-set light shows and 3 make-your-own shows included. Set from the factory to only operate when parked, but can be unlocked for off-road and emergency personnel use.
Disable Navigation in-motion lockout - enter addresses while the vehicle is moving
Disable camera lockout – use the backup camera and/or added cargo/front/undercarriage camera at any speed for any length of time
Auto Traction Kill - can be set to turn off traction control upon start-up
Auto StopStart Disable - can be set to disable AutoStopStart upon vehicle start-up 0-30 and 0-60 timers
Enable/Disable/Change ParkSense Configuration
TurnCAM – can turn on backup camera whenever turn signals are used (great for when the doors are off)
0-30 and 0-60 timers
– Axle Locker control (Rubicon) – Engage lockers in 2WD and 4Hi on demand.
Sway Bar control in 2WD with automatic re-engagement at 30MPH
SwayKill – Disable sway bar on demand in any drive mode, any speed.
Cooldown mode - run engine fans when Jeep is off, to aid in cooldown
Winch mode – raise engine idle to 2000 RPM while winching or jumping another vehicle
Dark Mode- Turns off all exterior lighting and dash/radio/shifter lights while parked with engine running.
Display DTC’s – Shows the diagnostic codes that’s making the check engine light come on.
Rock Crawl: Can lock all four brakes by pressing steering wheel buttons to hold the vehicle still, especially helpful when off-road.
Button Mapping: Use cruise up, down and right buttons as quick-access to some of Tazer JL’s functions, when cruise control is off.
TC Kill – Tuns off traction control, stability control and ABS.
Clear Check engine light